Check oil, coolant, and fuel ( oil & coolant added if needed)

Inspect unit for any leaks, oil, coolant, and air

Check anti-freeze protection

Service and clean batteries, connectors, and cables

Load test batteries, check the electrolyte level

Check battery charger

Test safety shutdowns & governor operation

Check fuel system for water

Check day tank / (transfer pump) operation if applicable

Check block heaters and accessories

Check all wiring AC and DC

• Check all meters and gauges

Check exhaust system

Test automatic transfer switches

File service reports and recommendations

Replace crankcase oil and filters ( old oil disposed of an EPA approved manner)

Replace fuel filters

Replace coolant conditioner filters (as required)

Service crankcase breather system

Check air filter if replaced, it will be done at an added cost)

Inspect turbocharger clearances

Adjust battery charger (if batteries are replaced it will be done at an added cost)

Check fuel tank for water if applicable

Check operation of day tanks / (transfer pump) and fuel tanks if applicable

Inspect hoses, belts, clamps, and fuel lines

Install water conditioner ( as required)

Test safety shutdowns, governor operation & governor oil if applicable

Check operation without load, with building load if possible

Record operation performance

Check operation of all automatic transfer switches

All testing to be scheduled with building personnel

File service reports and recommendations

Lube fan hub bearings if applicable

Replace plugs, points, and condenser if applicable

Inspect/lubricate rear bearings if applicable

Lubricate over speed switch